Autocommit from 2025-03-29 08:17:20

Klipper version: v0.12.0-382-ga18c74be0

Moonraker version: v0.9.3-3-gccfe32f

Mainsail version: v2.13.2

octopus_pro_1.1.cfg

@@ -4,6 +4,10 @@ canbus_uuid: afcf80281237
 [temperature_sensor OctopusPro]
 sensor_type: temperature_mcu
 
+[temperature_sensor Chamber]
+sensor_type: ATC Semitec 104NT-4-R025H42G
+sensor_pin: PF4
+
 [output_pin ps_on]
 pin: PE11
 value: 1
@@ -155,30 +159,42 @@ stepper: stepper_x, stepper_y
 idle_speed: 0
 fan_speed: 0.6
 
-[heater_fan Nevermore]
+#[heater_fan Nevermore]
+#pin: PE5
+#heater_temp: 90
+#max_power: 1.0
+#kick_start_time: 0.5
+#heater: heater_bed
+#fan_speed: 1
+
+[fan_generic Nevermore]
+## Nevermore - FAN5 on Octopus
+## Adjust if you use a different board or a different terminal.
 pin: PE5
-heater_temp: 90
-max_power: 1.0
-kick_start_time: 0.5
-heater: heater_bed
-fan_speed: 1
 
-[temperature_fan chamber]
+
+#[temperature_fan chamber]
+#pin: PD14
+#max_power: 1.0
+#shutdown_speed: 0.0
+#kick_start_time: 5.0
+#cycle_time:0.01
+#off_below:0.1
+#hardware_pwm: True
+#sensor_type: ATC Semitec 104NT-4-R025H42G
+#sensor_pin: PF4
+#min_temp: 0
+#max_temp: 70
+#target_temp: 40
+#control: watermark
+#gcode_id: C
+
+# this is the exhaust fan
+# comment out it if you don't have exhaust fan
+[fan_generic exhaust_fan]
 pin: PD14
-max_power: 1.0
-shutdown_speed: 0.0
-kick_start_time: 5.0
-cycle_time:0.01
-off_below:0.1
-hardware_pwm: True
-sensor_type: ATC Semitec 104NT-4-R025H42G
-sensor_pin: PF4
-min_temp: 0
-max_temp: 70
-target_temp: 40
-control: watermark
-gcode_id: C
-
+cycle_time: 0.01
+hardware_pwm: false
 
 [multi_pin soc_pin]
 pins: PD12, PD13